Advertisement
fig.2
fig.3
7. OPERATION
WARNING! This tool is not intended for continuous professional use.
‰
WARNING! Ensure grinder is unplugged from the mains power supply before changing accessories.
‰
7.1.
PREPARATION
7.1.1.
Assemble grinding disc according to section 5.1. and position handle to suit the task.
7.1.2.
Ensure the disc safety guard is correctly positioned.
7.1.3.
Plug grinder into the mains power supply.
7.1.4.
The On/Off switch (fig 6.1) is designed to avoid starting should the switch be pressed in error.
7.1.5.
Once plugged into the mains supply, start the grinder by sliding the switch forward - it will latch in the 'On' position.
WARNING! When the grinder first starts it will kick to the right, you must ensure therefore that the tool is securely gripped in both
‰
hands. Especially important is the position you choose to secure the auxiliary handle in order to maintain stability.
7.1.6.
To switch off the machine push the back of the On/Off button down. The button will slide backward under spring pressure to the safety
position and the machine will stop.
WARNING! Before grinding ensure you wear approved safety goggles, ear defenders, dust mask if grinder generates dust and
‰
safety gloves, and that all other safety instructions in Section 1 are followed carefully.
GRINDING
7.2.
7.2.1.
The key to effective operating is controlling the pressure and surface contact between the disc and the workpiece.
WARNING! DO NOT switch the grinder on whilst the disc is in contact with the workpiece. Bring the rotating disc to the workpiece.
‰
7.2.2.
Allow the disc to reach full speed before starting to grind.
7.2.3.
Grind flat surfaces at an angle of between 10 and 20°.
7.2.4.
Too great an angle will cause a concentration of pressure in one small area resulting in gouging or burning of the surface.
7.2.5.
When grinding is complete allow the workpiece to cool. DO NOT touch the hot surface.
7.2.6.
Unplug the grinder from the mains power supply, clean and store in a safe, dry, childproof area.
8. MAINTENANCE
WARNING! Ensure the grinder is disconnected from the mains power supply before attempting any maintenance.
‰
8.1.
Keep the grinder ventilation slots clean and free from obstructions. If available, blow compressed air into the vents to clear any internal
dust (safety goggles must be worn when undertaking this process). Keep the outer case of the grinder clean and free from grease.
DO NOT wash with water or use solvents or abrasives.
8
© Jack Sealey Limited
Original Language Version
fig.6
fig.4
fig.5
S0530.V2, S0685.V2 | Issue 4 (H,F) 24/10/2018
Advertisement
