Figure 1.2 Base Module Rear View; Table 1.2 Name Of Each Component (Rear Side Of The Base Module) - Fujitsu Storage ETERNUS LT140 User Manual

Chapter 1 Hardware Configuration
1.1 Module
No.
Handle for pulling out the right maga-
19
zine or Mailslot
20 Hole for manually releasing the right
magazine
Screw for attaching the LT140 to the
21
rack
*1: Only installed for Base Modules.
Expansion Modules do not have a power button, an LED panel, an LCD screen, operation buttons, and a USB port.
■
Rear view

Figure 1.2 Base Module rear view

Table 1.2 Name of each component (rear side of the Base Module)
No.
1 Power Supplies
2 Half-Height Tape Drive Bays
3 Library Controller
(for Base Modules)
4 Module Alignment Mechanism
FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Site Planning-
Name
Used for pulling the right magazine or Mailslot out of the mod-
ule.
Used for manually unlocking the right magazine.
—
1 2
Name
•
Base Modules are installed with a single PSU as standard. A
second PSU for redundancy is optional.
•
Optional for Expansion Modules.
A maximum of three half-height drives can be installed.
—
The mechanism for locating modules when connected.
12
Copyright 2018 FUJITSU LIMITED
Detail
3
Detail
P3AG-3712-01ENZ0
4