Dhcp; Dhcp Settings - TP-Link TL-WR641G User Manual

If the numbers of connected wireless stations go beyond one page, click the Next
button to go to the next page and click the Previous button to return the previous page.
Note: This page will be refreshed automatically every 5 seconds.

5.6 DHCP

Figure 5-14 the DHCP menu
There are three submenus under the DHCP menu (shown in figure 5-14): DHCP
Settings, DHCP Clients List and Address Reservation. Click any of them, and you will
be able to configure the corresponding function. The detailed explanations for each
submenu are provided below.

5.6.1 DHCP Settings

The router is set up by default as a DHCP (Dynamic Host Configuration Protocol) server,
which provides the TCP/IP configuration for all the PCs that are connected to the router
on the LAN. The DHCP Server can be configured on the page (shown in figure 5-15):
DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you
must have another DHCP server within your network or else you must manually
configure the computer.
Start IP Address - This field specifies the first of the addresses in the IP address
pool. 192.168.1.100 is the default start address.
End IP Address - This field specifies the last of the addresses in the IP address
pool. 192.168.1.199 is the default end address.
Address Lease Time - The Address Lease Time is the amount of time a network
user will be allowed connection to the router with their current dynamic IP Address.
Enter the amount of time, in minutes, which the user will be "leased" this dynamic
TL-WR641G 108M Wireless Router User Guide
Figure 5-15 DHCP Settings
- 26 -