More About Supervisory Monitoring - 3Com NBX 3101SP Telephone Manual

106 C 7: G
HAPTER ETTING
More About
Supervisory
Monitoring
M Y T
ORE FROM OUR ELEPHONE
utility and go to My Calling Privileges > Call Permissions. You are
allowed to activate Call Privacy if the Call Privacy feature is enabled.
You can activate Call Privacy before a call (for example, by going off-hook
and dialing Feature code 428 and then dialing an internal or external
call), or during a call (for example, dialing Feature code 428 after
answering an incoming call). The administrator may also map Feature
code 428 to one of your telephone system access buttons.
To activate (toggle on) Call Privacy:
Press Feature + 428. Or press the Call Privacy Access button if one is
programmed on your telephone.
The message "CALL PRIVACY ON" appears on the display panel to
indicate that Call Privacy is enabled.
In the case of an incoming call, Call Privacy cannot be activated while the
session is alerting. In this case, you must answer the incoming call before
activating Call Privacy.
To deactivate (toggle off) Call Privacy:
While Call Privacy is on, press Feature + 428 again. Or press the Call
Privacy Access button if one is programmed on your telephone.
The message "CALL PRIVACY OFF" appears on the display panel to
indicate that Call Privacy is disabled.
When any active Call Privacy session ends, (for example: you activate Call
Privacy, initiate a call, and then exit the call) the Call Privacy settings are
no longer applicable and the next call is open to monitoring.
These usage tips and limitations apply to Supervisory Monitoring:
A supervisor can only monitor an agent who is a member of the
domain associated with the domain password.
You can log in to the NBX NetSet utility and go to System Group
Settings > Supervisory Monitoring to view the status on whether or
not you can be monitored. Also, if you are a user and have the domain
password, you can log in and view domain membership information.
S
YSTEM