WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.
1. Lift the receiver up to the frame of the vehicle. Locate the large holes in the receiver brackets over the rivet heads in the
frame.
2. Install four (4) 1/2" serrated washers over four (4) 12mm hex bolts and insert the bolts up through the receiver brackets
and into the weld nuts in the frame. See the diagram above.
3. Install two (2) bolt plates over two (2) 1/2" carriage bolts and insert the bolts down through the frame and the receiver
brackets. Install 1/2" serrated washers and 1/2" lock nuts on the bolts. See the diagram above.
4. Torque the 12mm bolts to 75 LB-FT.
Torque the 1/2" nuts to 75 LB-FT.
For Installation Assistance or Technical Help, Call 1-574-537-6339
INSTALLATION INSTRUCTIONS
TOYOTA TUNDRA
1/2" SERRATED WASHER
1/2" CARRIAGE BOLT
1/2" SERRATED WASHER
1/2" LOCK NUT
N75105-12-9-02
EWO3289
PLYMOUTH, MI
USE ONLY TOWING PRODUCTS SUPPLIED OR APPROVED BOLTS,
LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH
12mm HEX BOLT
BOLT PLATE
(OVER)
© 2002 TOWING PRODUCTS
Product No.
IMPORTANT NOTES
TOOLS REQUIRED
3/4" SOCKET
18mm SOCKET
TORQUE WRENCH
TO WELD NUTS IN THE FRAME
Litho in USA
33049
75105
SMALL PARTS
PACKAGE K75105