2.1
Detaching the Base (for VESA Wall
Mount)
VP279QG
To detach the base, perform the following:
1.
Disconnect power and signal cables. Carefully put the front of the
monitor face down on a clean table.
2.
Turn the screw counter-clockwise to loosen the screw located at the
bottom of the base.
3.
Remove the base from the stand assembly.
4.
Remove the stand cover. Then loosen the 4 screws to remove the
arm.
5.
Align and install the wall mount bracket on the rear of the monitor.
•
We recommend that you cover the table surface with soft cloth to prevent
damage to the monitor.
•
Hold the base while removing the screw.
•
The VESA wall mount kit ( 100 x 100 mm) is purchased separately.
•
Use only the UL Listed Wall Mount Bracket with minimum weight/load
22.7kg (Screw size: M4 x 10 mm).
ASUS LCD Monitor VP279 Series
Screw holes for VESA wall mount
(100 x 100 mm)
1-8