Asus ROG MAXIMUS XII EXTREME Manual page 65

12
11
• Before you install or remove the DIMM.2 card, ensure that the ATX power supply is
switched off or the power cord is detached from the power supply. Failure to do so
may cause severe damage to the motherboard or DIMM.2 card.
• The DIMM.2 card is notched to fit in only one orientation. Ensure that the notch on
your card is aligned correctly with the DIMM.2 slot before inserting the card.
• DIMM.2 module supports PCIe 3.0 x4 M Key design and type 2242 / 2260 / 2280 /
22110 PCIe storage devices.
• These sockets support IRST (Intel
• The DIMM.2 Slots (M.2_1/2) are disabled by default. Please adjust BIOS settings to
enable DIMM.2 Slots.
• When using the DIMM.2 Heatsink module, we recommend removing the M.2 SSD's
default thermal heatsink before installing the M.2 SSD to the DIMM.2 Heatsink
module.
• If your M.2 SSD does not feature a flash chip on the back, please remove the default
M.2 pads on your DIMM.2 module and replace them with the bundled taller M.2 pads.
ROG MAXIMUS XII EXTREME
13
14
Rapid Storage Technology).
®
16
15
2-17