Features
Night Transfer
Incoming calls to your group can be routed to different destinations, based on either two- or three-call
routing (ringing) patterns which are set in system programming. The Night Transfer LED indicates
the active routing pattern:
Up to four Night Transfer (
buttons can be assigned and controlled independently. Check with the System Administrator for any
additional information.
To enable/disable Night Transfer
Night Transfer
Press
toggle Night Transfer
ON/OFF (two-ring pattern)
...or, if your system is
programmed for three-ring
patterns, the LED will flash
instead. Press
again (three-ring pattern), to
activate Night Mode.
Strata CT ACD Supervisor November 2001
DAY
DAY 2
NIGHT
Night Transfer
to
The Night Transfer LED is ON if you are programmed for a
two-ring pattern.
You are in Day2 Mode. The LED indicators for three-ring
patterns are: Night Mode (LED is ON); Day Mode (LED is
OFF; and Day2 Mode (LED is flashing).
Night Transfer
,
The Night Transfer LED is ON.
Three-Pattern
OFF
FLASH
ON
) and Tenant Night Transfer (
Night Transfer
Two-Pattern
OFF
N/A
ON
Night Transfer 1~4
)
19