Table of Contents
Advertisement
Move up and down
by pushing
MENU UP,DOWN
-- 7 OPTION
OUTPUT
RGB SYNC
SHADING
BAUD RATE
OSD OUTPUT
7 4 Changing RGB SYNC
Move the " " to RGB SYNC by pushing [MENU UP], [MENU DOWN] buttons.
Select G, ALL ON or ALL OFF by pushing [DATA UP], [DATA DOWN] buttons.
* When Y/P
/P
is selected at OUTPUT, RGB SYNC change cannot be performed.
b
r
7 5 Changing RS232C baud rate
Move the " " to BAUD RATE by pushing [MENU UP], [MENU DOWN] buttons.
Select either 9600bps or 19200bps by pushing [DATA UP], [DATA DOWN] buttons.
7 6 Changing OSD OUTPUT mode
Move the"→" to OSD OUTPUT by pushing [MENU UP], [MENU DOWN] buttons.
Select either ALL ON, Analog, or Digital by pushing [DATA UP], [DATA DOWN] buttons.
ALL ON can be performed in the both analog and digital monitor.
If Analog is selected, it outputs only for analog.
If Digital is selected, it outputs only for digital.
Please select a mode depending on the type of the monitor display that is connected.
If incorrect mode is selected, the display might be disappear.
In that case, please cycle the power, and refer to section "7.2 (8) Returning to factory settings". Please
return other settings again.
8 Returning to factory settings
The contents set of each scene file can be returned to the factory default status (preset status).
(1) Select a scene file to set to the factory default status by [FILE] button.
(2) If the color bar pattern or characters are displayed on the screen, press the [DISP] button to disable the
color bar pattern and character display.
(3) Push [MENU DOWN] and [DATA DOWN] buttons simultaneously for approx. 1 second.
(4) The preset operation starts. When the preset operation finishes, the character PRESET OK is displayed
for approx. 1 second.
Select the desired
value by pushing
DATA UP,DOWN
--
<FILE A>
RGB
G
OFF
9600bps
ALL ON
OUTPUT Y/P
b
RGB SYNC
G, ALL ON, ALL OFF
SHADING MANUAL Setting
RS232C baud rate 9600bps, 19200bps
OSD OUTPUT
30
/P
, RGB
r
128 to 127
ALL ON, Analog, Digital
Advertisement
Table of Contents
