Toshiba TDP-P9 Owner's Manual page 29

Note
• The start-up screen will disappear after a moment. You can also configure the start-up
screen not to appear via the Default setting menu
• The first time you use the projector after purchase, the language selection menu will be
displayed.
• Do not touch the lens directly with your hand. If fingerprints or stains are left on the
projection lens surface, they may interfere with the projector's ability to project images
on the screen.
„
Turning the power off
Press the ON/STANDBY button.
A message appears on the screen, confirming that you wish to shut off the power. This
message will disappear after a moment. (This operation is no longer valid after the
message disappears.)
Press the ON/STANDBY button again.
The screen turns off, but the internal cooling fan continues to operate for a short while.
Then, the projector goes into standby mode.
During cooling, the ON/STANDBY and LAMP indicator flash. In this state, the power
cannot be turned back on.
If you are in a hurry, there is no problem with unplugging the power cord in this state.
In standby mode.
Note
• The projector consumes about 8W of power in standby. We recommend that you unplug
the power cord if you will not be using the projector for an extended period.
Precaution
• If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.
.
p.36
29