Figure 34. Secure the hinges
Step 4.
Check the hinge cap for any appearance of sink. If the sink is visible, flip the LCD panel slightly and
press down on the hinge cap.
Figure 35. Press down on the hinge cap
Remove the camera module and MIC board
Make sure the following FRU (or CRU) have been removed.
"Remove the lower case" on page 26
"Remove the battery pack" on page 27
"Remove the upper case (with keyboard)" on page 38
"Remove the LCD panel" on page 41
Step 1.
Disconnect the camera connector.
.
Chapter 4
Removing a FRU or CRU
45