Toshiba PROSEC T3H User Manual page 65

F E D
B Abn Busy Status
B+1
Inside the parameter:
Transfer parameter
MID (network type)
CH (channel of self-station)
Target station No.
Request command
Transfer size
(number of words)
Register type
Leading address
Response time limit
Target-station IP address
Target-station UDP port No.
C B 8
0
Transmission error information (if TermSTS is H0B)
S20LP
2
1 or 2 (max. two S20LP's on T3H)
1 to 64
0 (fixed)
1 to 128
(max. 84 words for T or C register)
(designation across T511 and T512 is
not allowed)
H0000: XW/YW register
H0001: W register
H0002: LW register
H0003: RW register
H0004: D register
H0005: F register (CPU)
H 05: Expanded F register
(IC card, 8k words/bank,
H 06: Expanded F register
(IC card, 64k words/bank,
H0007: T register
H0008: C register
H0009: SW register
Designates the leading register address to be transferred
Specifies the time limit of the response from target-station. (0.1 s units)
When the bit F is set to ON, the following default value is used.
S20LP ...... 4.1 s
Ethernet ... 30 s
N/A
N/A
2. Expanded Functions
7
TermSTS
3
1 to 4 (max. four EN311's on T3H)
0 (fixed)
H0021: Register read/write
(for other commands, refer to EN311
manual)
1 to 485
(max. 323 words for T or C register)
(designation across T511 and T512 is
not allowed)
is bank No. 01 - 0F)
is bank No. 01 - 02)
Designates the IP address of the
target-station
Designates the UDP port No. of the
target-station
0
Ethernet
63
User's Manual