Before Use; During Use; After Use - TekPower TP-3005D Manual

Do not allow any foreign matter such as metal or inflammable substance to get into the instrument
via the air holes. The penetration of any foreign matter from the ventilation holes could result in fire,
electrical shock, or power failure.
Use this instrument with the rated AC power sources. Use of this instrument with a voltage other
than specified could result in electrical shock, fire or power failure. The usable power voltage range
is marked on the rear panel.
Do not remove either the cover or panel.
Do not modify this instrument.
Avoid use of damaged cables.

1.1 BEFORE USE

1. Make sure the POWER switch is at the "0" position and connect the power cord to the power supply.
2. To set the constant voltage output: Push the POWER SWITCH to "I" position. Adjust the VOLTAGE
COARSE / CURRENT COARSE tune knob for roughly adjustment or VOLTAGE FINE / CURRENT
FINE tune knob for fine adjustment. Once the voltage or current value is reached, to desire value
appear on Display Panel.

1.2 DURING USE

1. Ensure the voltage and current set to zero, prevent a undesired output damage the circuit.
2. The supplied voltage should be within 110V AC or 220V AC±10% (60/50Hz) and the system is
capable for supplying the maximum power consumption as indicated on section 3.1.
3. Keep a distance at least greater than 10cm between the power supply and other things for airy
reason when usage. Do not place this power supply in a hot, dusty, wet, corrosive gas stage or near
the poison substance.
4. This power supply need warm up 30 minutes to meet the specification section 3.2.
5. Keep hands and face away from the heat sink.
6. Do not touch the heat sink during operation.

1.3 AFTER USE

1. Once the operation completed, remove all connection to the power supply, especially the power
source.
2. Wait the power cold down.
3. Store in a dry, well air and non-dusty environment.
3