General Problems With The Washing Machine - Miele PWM 507 Hygiene Operating And Installation Instructions

Hide thumbs Also See for PWM 507 Hygiene:
Table of Contents

Advertisement

General problems with the washing machine

Problem
The machine shakes
during the spin cycle.
The pump makes
strange noises.
Large amounts of
detergent residue
remain in the detergent
dispenser drawer.
Fabric softener is not
completely dispensed
or too much water
remains in the 
compartment.
The display is in a
different language.
The washing machine
did not spin the laundry
as usual. The laundry is
still wet.
Possible cause and remedy
The machine feet are not level.
 Level the machine and adjust the feet correctly.
This is not a fault. Slurping noises occur at the end
of the pump sequence as a normal part of
operation.
The water pressure is too low.
 Clean the filters in the water inlet.
Powder detergent used in conjunction with water
softeners tends to become sticky.
 Clean the detergent dispenser drawer and, in the
future, add washing powder to the dispensing
drawer first, and then add the water softener.
The siphon tube is not correctly positioned or
clogged.
 Clean the siphon (see "Cleaning and care -
Cleaning the detergent dispenser drawer").
A different language has been selected.
 Switch the washing machine off and then on
again.
The set operator language will appear in the display.
The operator language has been changed.
 Select the language you require (see "Supervisor
level - Language").
The machine detected an imbalance during the final
spin and reduced the spin speed automatically.
 Include both large and small items in the load as
this will give better distribution.
Problem solving guide
49

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pwm 507

Table of Contents