Advertisement

Quick Links

D R I L L I N G M A C H I N E
HU 13-2 N

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HU 13-2 N and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Huvema HU 13-2 N

  • Page 1 D R I L L I N G M A C H I N E HU 13-2 N...
  • Page 2: Table Of Contents

    able of conTenTs General safety rules for all machines Applications Main specifications Range of spindle speeds Unpacking and checking contents Getting to know your drill press Assembly Lubrification Operation and maintenance Wire diagram Troubleshooting Exploded drawing and parts list CHANGES AND T YPING ERRORS RESER VED...
  • Page 3: General Safety Rules For All Machines

    HU 13 l aserdrill 1. G eneral safeTy rUles for all macHines N.B.: Read the instructions carefully in order to avoid any problems. As with all machinery there are certain hazards involved with operation and use of this machine. Using the machine with respect and caution will considerably lessen the possibility op personal injury.
  • Page 4: Applications

    Always wear safety glasses. 2. A PPLICATIONS This drill press is intended for drilling holes in ferrous and non-ferrous metals and woods. The machine has a light and handy design and can be easily operated. The HU 13 laserdrill is widely used in machine works and repair shops. 3.
  • Page 5 LIST OF LOOSE PARTS IN THE BOX AND BAGS...
  • Page 6: Getting To Know Your Drill Press

    6. G ETTING TO KNOW YOUR DRILL PRESS CHANGES AND T YPING ERRORS RESER VED...
  • Page 7: Assembly

    7. A SSEMBLY re A Install (3) M8x20 bolts in each hole through column support and base and tighten with wrench. Slide table support assembly into column. Install support lock handle from left side into table support and tighten by hand.
  • Page 8: Troubleshooting

    Indication Composant/objet Fabricant Motor Motor AC250V/1PH/400W Magnetic switch 250VAC/16A KJD12 Push button- 250VAC/12A HY57B Emergency Stop Micro switch 250VAC/16A KW-7-3B Micro switch 250VAC/16A 11. T roUblesHooTinG Trouble Probable couse Remedy Noisy Operation 1.Incorrect belt tension. 1.Adjust tension. 2.Dry Spindle. 2.Lubricate spindle. 3.Loose spindle pulley 3.Checking tightness of retaining nut 4.Loose motor pulley...
  • Page 9: Exploded Drawing And Parts List

    12. E XPLODED DRAWING AND PARTS LIST CHANGES AND T YPING ERRORS RESER VED...
  • Page 10 No. Type Q’ty Name No. Type Q’ty Name Base Screw Nut Column Seat Washer Screw-hex HD Motor Mounter Column Screw Screw-hex Soc Set Motor Bracket Collar-rack Case Gear-helical Switch Box Gear Pin Screw Support Switch Cover Plate Table Crank Screw Table Emergency Stop Screw-hex HD...
  • Page 11 All rights reserved. No part of this booklet may be reproduced in any form, by print, photoprint, microfilm or any other means without written permission from the publisher. © 2010, Huberts bv, Kennedylaan 14, Veghel, the Netherlands. Internet: www.huvema.nl CHANGES AND T YPING ERRORS RESER VED...
  • Page 12 Copyright © Huberts BV. All rights reserved.

Table of Contents