Table of Contents
Advertisement
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Fault
Possible cause
The oven does
The fuse has
not work.
blown.
Power cut.
Power cut.
0
lights up on
the display with
some zeros.
The oven does
There is dust on
not heat up.
the contacts.
The oven door
The oven door has
does not open.
been locked by
the self-cleaning
The
symbol
H
function
lights up on the
display panel.
The oven does
The oven is in
not heat up. A
demo mode.
small square
lights up on the
display
.
Ü
The display
The appliance has
been automatically
shows
.
"‰
turned off.
Error messages
When the display panel shows an error message with
the
button. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message
Possible cause
A button has
"‹‚‚
been pressed for
too long or has
got stuck.
The door lock
"‚‹‡
has been acti-
vated with the
door open.
The temperature
"‚‚†
inside the oven is
too high.
Solution/advice
Check the condition of
the fuse in the fuse box.
Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
Set the time once again.
Turn the control knobs
several times in both
directions.
Wait until the oven has
cooled and the
turns off.
.
x
Disconnect the fuse from
the fuse box and recon-
nect after around
20 seconds. Then, within
approx. 2 minutes, press
the
button for approx.
h
4 seconds until the
square is turned off
Turn the function control
knob to the zero setting.
Solution/advice
Press all of the buttons
one by one. Check if any
button is stuck, covered
or dirty.
Press the
button. You
0
can now begin program-
ming again.
The oven door is locked
and heating has stopped.
Wait until the oven has
cooled. Press the
ton and reset the time.
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical Support
Service.
Changing the oven bulb
If the oven light bulb is damaged it must be replaced. Special
25 W, E14, 220 V-240 V heat-resistant light bulbs (to 300 ºC
temperature) can be obtained from the Technical Support
Service or in specialist shops. Only use this type of bulb.
:
Risk of electrical discharge and the resulting shock.!
Disconnect the appliance from the mains. Ensure that this is
turned off.
Place a dishcloth into the cold oven to avoid damage.
1.
Remove the glass protection by unscrewing it to the left.
2.
symbol
H
Replace the bulb with a similar bulb.
3.
Screw the protection glass back into place.
4.
Remove the dishcloth and switch the oven back on at the
5.
mains.
.
Ü
Protective glass panels
Damaged protective glass panels must be replaced. Protective
glass panels cay be obtained from the Technical Assistance
Service. Please quote your appliance's product number and
production number.
"
, press
0
but-
13
Advertisement
Table of Contents
