Putting Into Operation With The Pushbutton; Checks After Commissioning - Siemens SITRANS AW 7MP3112 Series Operating Instructions Manual

8.2

Putting into operation with the pushbutton

Pushbutton during commissioning
Time pressed
Requirement: The battery connector must be disconnected.
1. Press the pushbutton
2. Insert the battery connector
3. Keep the button pressed.
Keep pressed 10 ... 15 s
Keep pressed 20 ... 25 s
Note
Read the section "Operator control (hardware)" (Page 39) to see which functions you can
perform during operation of the WirelessHART adapter by pressing the pushbutton.
8.3

Checks after commissioning

Checking the commissioning of the WirelessHART adapter
During commissioning of the WirelessHART adapter, make the following checks:
● Is the battery unit correctly inserted and the battery connecting cable correctly plugged in?
● Is the device ready for operation and do the LEDs light up after briefly pressing the
pushbutton?
Checking after commissioning of the WirelessHART adapter
After commissioning of the WirelessHART adapter, make the following checks:
● Is the housing cover screwed tight?
WirelessHART Adapter SITRANS AW200
Operating Instructions, 02/2020, A5E02777161-AA
Function
-
The red LED lights up: No function
The red LED flashes.
● Frequency 2.5 Hz (2.5 times/s on and 2.5 times off):
● The configuration is reset to the default settings of the vendor.
The red LED flashes.
● Frequency 1.25 Hz (1.25 times/s on and 1.25 times off):
● The firmware and the configuration are reset to the default
settings of the vendor. .
Commissioning (hardware)
8.3 Checks after commissioning
45