Table of Contents
Advertisement
Manual Preset Programming
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROGRAM.
➜
starts flashing.
PROG
➜
The next available preset number is displayed
for selection.
To store the radio station to another
preset number
●
Press í or ë to select the desired preset
number.
3
Press PROGRAM again to store the radio
station.
➜
disappears.
PROG
●
Repeat steps 1–3 to store other radio stations.
To exit manual preset mode
●
Press STOP 9 on the system.
Notes:
– If you attempt to store more than 40 preset
radio stations, "PROGRAM FULL" is displayed.
– During programming, if no key is pressed within
25 seconds, the system will exit the programme
mode automatically.
Tuning to preset radio stations
●
Once you've programmed the radio stations,
press í or ë to select the desired preset
number.
➜
The preset number, radio frequency, and
waveband are displayed.
For Recording, please refer to "Tape
Operation/Recording".
Radio Reception
Changing tuning grid
all versions)
In North and South America, the frequency step
between adjacent channels in the MW band is
10 kHz (9 kHz in some areas). The preset
frequency step in the factory is 10 kHz.
Changing the tuning grid will erase all
previously stored preset radio stations.
Press and hold 9 on the system in the tuner
mode.
➜
The display will show "GRID 9" or
"GRID 10".
Notes:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
(not available for
19
Advertisement
Table of Contents
