Page 3
Environmental protection This product has been designed to comply with the environmental protection requirements. The storage, use, and disposal of this product must meet the applicable national laws and regulations.
Page 4
Obtaining documentation To access the most up-to-date H3C product documentation, go to the H3C website at http://www.h3c.com.hk. To obtain information about installation, configuration, and maintenance, click http://www.h3c.com.hk/Technical_Documents To obtain software version information such as release notes, click http://www.h3c.com.hk/Software_Download Technical support service@h3c.com...
LSVM1S9800FAN Introduction to LSVM1S9800FAN The LSVM1S9800FAN fan tray provides powerful cooling and heat dissipation for the switch internal components. It blows cool air into the switch from the power side to the port side. It has five fans and features small size, fast heat dissipation, and hot swapping.
Green—The fan tray is operating correctly. • Red—No fan tray is installed or the fan tray is faulty. • LSVM1S9800FAN specifications Table 1 LSVM1S9800FAN specifications Item Specification Five 40 × 40 × 56 mm (1.57 × 1.57 × 2.20 in) Number of fans...
LSVM2S9800FAN Introduction to LSVM2S9800FAN The LSVM2S9800FAN fan tray provides powerful cooling and heat dissipation for the switch internal components. It blows exhaust air out of the switch from the port side to the power side. It has five fans and features small size, fast heat dissipation, and hot swapping.
The switch provides a LED on the power side panel to indicate the operating status of the fan tray. When the switch is running, the LED can have the following states: Green—The fan tray is operating correctly. • Red—No fan tray is installed or the fan tray is faulty. •...
• Make sure you install two fan trays of the same model for the • switch. The installation and removal procedures for the LSVM1S9800FAN and LSVM2S9800FAN are similar. Installing a fan tray To install a fan tray: Wear an ESD wrist strap, and make sure it makes good skin contact and is correctly grounded.
Page 11
Verify the fan tray installation by examining the fan tray LED on the power side. If the LED is steady green, the installation is correct. If the LED is in red, the fan tray is faulty. Remove and re-install the fan tray. If the problem persists, contact H3C Technical Support.
Page 12
Figure 3 Installing a fan tray NOTE: If you insert the fan tray with the upside down, you cannot • completely insert it into the slot. If this happens, pull the fan tray out and then insert it again with the upside up. If the captive screws cannot be attached tightly, check for the •...
Replacing a fan tray CAUTION: When you replace a fan tray from a running switch, be cautious • of electricity hazards, and do not touch the rotating fan to avoid bodily injury. If a fan tray fails, finish replacing the fan tray within 5 minutes. If •...
Need help?
Do you have a question about the LSVM1S9800FAN and is the answer not in the manual?
Questions and answers