Pioneer CJ-V55 Service Manual page 62

CJ-V55
7.1.2 CD SECTION
1 preparations!
• Set a magazine in the first and third modules of
the CD main unit
• Connect remote control unit (RU-V101) to the CD
main unit
1. Rough adjustment of the select positon
(1) Align the distance from the upper side of the
sensor plate to that of the main chassis to 7mm
by turning screw ®.
2. Adjustment of the select position
(1) First, proceed as follows.
(i)Press the lOkeys in the sequence of fl~l+[8l+ STILL
/STEPII^ (DISC SELECT) key + STILL/STEP ◄ II
(DISC RETURN)key. When the operation is
completed, check that the gap between the top of
the rotation lever and the upper side of the sixth
tray in the magazine is 0.3 -«2.
©If the distance is not within the specified range,
turn screw ® to adjust the position of the sensor
plate and press the lOkeys again in the sequence of
[f]
+ [83+
STILL/STEP !!► (DISC SELECT) key +
STILL/STEP ◄!! (DISC RETURN) key until the
distance comes within the specified range.
© Push the lOkeys in the sequence of [6] + STILL/
STEP II ► (DISC SELECT) key + STILL /STEP ◄ I!
(DISC RETURN) key and check that the gap between
the top of the rotation lever and the upper side of
the sixth tray in the magazine is 0.3mm ± 0.1mm.
92