4. NAME AND FUNCTION OF EACH PART
4.2
Right-side panel
4.2.1
DIP switch
Note: After operating the DIP switches, press the RESET/START switch to apply the
• Selecting target CPU core (SW1)
OPEN
ON
• Selecting ICD mode/flash programmer mode (SW2, SW3)
SW2
OPEN
ON
OPEN
ON
ICD mode:
Flash programmer mode: Mode for operating the S5U1C33001H independently as a flash programmer (see relevant section)
12
Fig. 5 Right-side panel
settings.
Table 3-1 DIP SW1 setting
SW1
Table 3-2 DIP SW2 and SW3 settings
SW3
OPEN
OPEN
ON
ON
Mode for executing the debug command from the debugger in a PC (see the relevant section)
C33
C17 (Not supported)
ICD mode
Flash programmer mode Erase → Write
Flash programmer mode Verify
Flash mode Erase → Write → Verify
EPSON
Setting
Setting
S1C33 Family In-Circuit Debugger
S5U1C33001H1400 Manual (Rev. 0.20)