Cleaning And Maintenance - Whirlpool WFCI75430 Health & Safety, Use & Care And Installation Manual

CLEANING AND MAINTENANCE

CLEANING THE OUTSIDE OF THE WASHER-DRYER
Use a soft damp cloth to clean the outer parts of the washer-
dryer.
CHECKING THE WATER SUPPLY HOSE
Check the inlet hose regularly for brittleness and cracks. If
damaged, replace it by a new hose available through our
After-Sales Service or your specialist dealer.
Depending on the hose type:
If the inlet hose has a transparent coating, periodically check
and should be replaced.
CLEANING THE MESH FILTERS IN THE WATER SUPPLY HOSE
1.
Close water tap and unscrew the inlet hose.
2.
washer-dryer.
1
2
washer-dryer.
Do not use glass or general purpose cleaners, scouring
powder or similar to clean the control panel – these
substances might damage the printing.
For water stop hoses: check the small safety valve inspection
window (see arrow). If it is red, the water stop function was
triggered, and the hose must be replaced by a new one.
For unscrewing this hose, press the release button (if
available) while unscrewing the hose.
3. Now unscrew the inlet hose on the back of the washer-
dryer by hand. Pull out the mesh lter from the valve
on the back of the washer-dryer with pliers and
carefully clean it.
4.
water tap and washer-dryer again. Do not use a tool
to connect the inlet hose. Open the water tap and check
that all connections are tight.
2
1
9