When the ProntoNEO does not receive an IR code in 5 seconds:
• You will hear an error beep;
• The label changes from Learning to Failed. The Learn sequence has failed.
• ProntoNEO will return to Learn mode. Return to step 5 of the Learn sequence
to relearn the button.
8 Go to other pages of the selected device with the Page Up and Page
Down buttons. Repeat steps 6 and 7 until you have copied all the
commands of the existing remote control.
9 Press Done when you have finished learning commands to the buttons
of your choice.
ProntoNEO returns to Use Mode. You can try out the new IR codes or select
another device to learn.
You do not have to wait for the OK or Failed to disappear. If you press another
button (soft or hard button), the ProntoNEO Learn sequence immediately goes
back to step 5.