XP SBC RU 510/00.3 05-02-2004 16:43 Pagina 6
Instructions for use
Setting the remote control
This is only necessary if your TV does not respond to the RU510.
If that is the case, the RU510 does not recognize the brand and/or model of
your TV and you need to program the remote control to do so.
The example belowinstructs you how to do this.
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
Look up the brand of your TV in the code list at the back of this
manual. One or more four-figure codes are shown for each brand.
Note the first code.
Keep keys '1' and '3' pressed simultaneously
for three seconds until the green LED
flashes twice and then remains lit
Then enter the code noted in step 2 using the digital keys.
The green LED will now flash twice.
If the LED flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
Point the RU510 at the TV and check that it responds as it should.
If the TV responds to all of the key commands, the RU510 is ready for
use. Do not forget to note your code.
If the TV does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.