Testing The Remote Control; Setting The Remote Control - Philips SRU740NC/05 Instructions For Use Manual

SRU740_10_v2.qxd 26-04-2005 15:18 Pagina 5

Testing the remote control

The remote control has been programmed to operate most Philips devices.
Because the SRU740 may use different signals for each brand and even for
different models of the same brand, it is advisable to test whether your
device responds to the SRU740.The example below (TV) instructs you how
to do this.You can repeat the same steps for other devices (DVD, video
recorder, etc.) which you want to operate using the SRU740.
Example of TV:
1
Turn your TV on manually or use the original remote control.
Tune to channel 1.
2
Press the SELECT key to select TV.
Press the key until the TV LED lights up.
If the LED does not light up, check whether the
battery is properly inserted
(see 'Replacing the battery').
3
Check whether all keys are working.
For an overview of the keys and their
functions see '3. Keys and functions'.
– If the TV responds as it should to all of the
key commands the SRU740 is ready for use.
• If the device does not respond at all or not to all of the
key commands, follow the instructions under
'Setting the remote control', or for online setup go to:
www.philips.com/urc

Setting the remote control

This is only necessary if your device does not respond to the SRU740.
If that is the case, the SRU740 does not recognize the brand and/or model of
your device and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.You can repeat the
same steps for other devices (DVD, video recorder, etc.) which you want to
operate using the SRU740.
Note:The third mode (DVD/VCR) can be used either for operating your
DVD player/recorder or your VCR (videorecorder).
Instructions for use
5