Charging The Pronto - Philips SBCRU960/05 User Manual

4 Plug the cable of the battery pack in
the connector.
5 Slide the battery cover back on.
Make sure the wires of the battery pack do not get stuck while sliding the
cover on.
After a few seconds, the Pronto starts up automatically and an introduction
screen appears. The Pronto beeps twice to indicate that it has finished starting
up.
Because the battery pack is not fully pre-charged, you need to charge it as
described below.

Charging the Pronto

For charging the Pronto, you have to place it in the docking station. When the
battery pack is running low, the Low Battery icon will appear on the Pronto.
You can charge the Pronto at any time; the battery pack does not have to be
entirely empty before recharging.
Note
When the battery pack is empty, the Pronto's settings are retained. You only need
to set the clock. However, you should recharge the Pronto as soon as possible to
ensure perfect performance.
User Guide
11
You can continue using the Pronto while it is being charged.
Before You Start