Signature Hardware FERGUSON CORNER SHOWER TRAY Installation Instructions

Table of Contents

Download this manual

FERGUSON CORNER SHOWER TRAY

INSTALLATION INSTRUCTIONS

Before you begin, review the instructions below carefully. Observe all

local plumbing and building codes when installing the shower tray.

Unpack and inspect the shower tray and parts for damage. If damage

is found, please call customer service at 1-866-855-2284. If you need

assistance while installing your shower tray, contact customer service.

Signature Hardware accepts no liability for any damage to floor, walls,

plumbing, etc., or for personal injury during installation. We recommend

consulting a professional if you are unfamiliar with installing bathroom

fixtures and plumbing.

Silicone Sealant

Tape Measure

Screwdriver

INSTALLATION:

1. To accommodate plumbing, prepare your floor as specified in drawing below. A 2" drain pipe should project ½" above

the floor line. We recommend measuring your shower tray for final dimensions.

Level

Hammer

12"

Drill

Pencil

12"

Ferguson Corner Shower Tray Installation Instructions

Table of Contents

Do you have a question about the FERGUSON CORNER SHOWER TRAY and is the answer not in the manual?

Page 1: Installation Instructions
1-866-855-2284. If you need assistance while installing your shower tray, contact customer service. Signature Hardware accepts no liability for any damage to floor, walls, plumbing, etc., or for personal injury during installation. We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures and plumbing.
Page 2 5. Lower the shower tray over the center of the drain pipe and set into place. Apply pressure to ensure that the compound is in contact with the entire bottom surface of the tray. 6. Verify that the tray is level and adjust as necessary. Ferguson Corner Shower Tray Installation Instructions...
Page 3 10. Drill pilot holes and attach the shower tray to the wall with 1-¼ " stainless steel screws. 11. Run a bead of silicone sealant along the top and base of the shower tray. Allow sealant to dry 24 hours before use. Ferguson Corner Shower Tray Installation Instructions...