Download Print this page

Philips SRU5150/86 Instructions For Use Manual: Replacing The Batteries; Troubleshooting

Philips universal remote control sru5150 5 out of 9 av devices.
Hide thumbs

Advertisement

Manual_SRU5150_86

5. Replacing the batteries

When the battery status indicator (
low and you should replace the batteries. All user settings will be retained when the old
batteries are removed.
1
Press the cover inward, slide it in the direction of the
arrow and remove the cover.
2
Insert 3 AAA/R03 batteries noting the + and -
configuration inside the battery compartment.
3
Place the cover back and click it firmly into place.
6. Support

Troubleshooting

Problem
Possible cause / solution
The device you want to operate does not respond at all when a key is pressed.
Point the remote control at the device and make sure that there are no obstructions
between the remote control and the device.
Make sure the function you wish to operate is available on the device.
Check if the battery status indicator (
If this is the case, insert new batteries.
The device you want to operate does not respond properly when a key is pressed.
Maybe the wrong code is programmed for the device during setup.
Try setting up the remote again. If the device still does not respond, call our helpline.
Check if the battery status indicator (
If this is the case, insert new batteries.
The teletext keys do not work.
Find out whether your TV is equipped with teletext.
You have difficulties operating all of the functions on your device.
Maybe the remote control has to be adapted to the model of the device.
Call our helpline for details.
ERROR appears on the display while adding an extra (advanced) function or when
trying to learn a key.
No signal from the original remote control is received for 20 seconds and the SRU 5150
stopped the adding / learning process. Start again from step 1.
An SRU 5150 key is pressed before a signal is detected and the SRU 5150 stopped the
adding/learning process. Start again from step 1.
The function you try to add is not available on the original remote control.
Make sure the original remote control is working properly.
Make sure the remote controls are properly aligned.
The IR signal of your original device is out of range. The SRU 5150 can only learn IR signals
with a carrier signal of 30-60kHz.
24-04-2007
15:42
) on the display starts blinking, battery power is
) on the display blinks (low battery power).
) on the display blinks (low battery power).
Pagina 11
Instructions for use
11

Advertisement

Chapters

   Also See for Philips SRU5150/86

   Related Manuals for Philips SRU5150/86

This manual also for:

Sru 5150

Comments to this Manuals

Symbols: 0
Latest comments: