Restoring The Original Functions Of Your Remote Control; Troubleshooting - Philips SRU4002X/10 User Manual

SRU4002_booklet_v4
10 ENGLISH

Restoring the original functions of your remote control

Follow the instructions below to revert the SRU 4002 back to the factory default settings:
1
Keep keys E (Aspect ratio) and A/V pressed simultaneously
for 3 seconds until the LED flashes twice (red) and then switches off.
– The SRU 4002 is now reverted back to the state it was when you first took
it out of the packaging.

5. Troubleshooting

• Problem
– Solution
• The device you want to operate does not respond when you press a key.
– Replace the old batteries with two new AAA type batteries.
– Point the SRU 4002 at the device and make sure that there are no obstructions between the SRU 4002 and
the device.
– Make sure the function you wish to operate is available on the device.
• The SRU 4002 does not respond properly to commands.
– The SRU 4002 memory is full. Revert the SRU 4002 back to the factory default settings in order to create
memory space. Refer to 'Restoring the original functions of your remote control'.
– The SRU 4002 stopped the learning / programming process after 60 seconds for no IR signals were received.
Check if the original remote control is working properly.
– Try setting the SRU 4002 again. If the SRU 4002 still does not respond, call our helpline.
• The TV volume reacts too slow.
– The SRU 4002 has not been set up yet. For this, follow the instructions under 'Setting the remote control'.
27-08-2008 13:20 Pagina 10