2. risk of Electrical Shock: 7. For proper automatic oper- General ation, make sure the pump connect only to a properly power cord is plugged into the Information ground ed receptacle. piggyback receptacle on the Septic tank is to be vented diaphragm switch cord.
possible, any dirt or trash from blockage, the foot and baf- Pump the outside of the pump before fle plate must be removed dismantling. by removing the three hex Servicing head cap screws (29) and the bottom plate removed 2. Check diaphragm switch. read the following instruc- removing the five hex if the unit is being operated...
Page 5
HydromaTic pumps continuity test, must of the seal and lifting it off have a small air vent hole be replaced. without damaging seal. inspect in the impeller cavity to let the seal face for any nicks or out trapped air. if this hole an uneven seating of seal face.
Page 6
18. reinstall the stator. Place the Do not fill the motor housing Pump stator (15) in the volute case completely — allow airspace (21) so the stator bolt holes Servicing for oil expansion. line up. Lay the stator plate (13) on the stator (15) and line 13.
Page 12
Limited Warranty HYDROMATIC warrants to the original consumer purchaser (“Purchaser” or “You”) of HYDROMATIC Sump Pumps, Effluent Pumps, Sewage Pumps (other than 2-1/2”), and Package Systems, that they will be free from defects in material and workmanship for the Warranty Period of 36 months from date of manufacture. Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance.
Need help?
Do you have a question about the HYDROMATIC OSP50 and is the answer not in the manual?
Questions and answers