Download  Print this page

Operation - AEG Fluxpower HE Series Installation And Start-Up Manual

Hide thumbs

Advertisement

INJURY HAZARD DUE TO ELECTRIC SHOCK!
The device is subject to high voltages, thus all safety instructions must be
scrupulously adhered to before performing any operation on Fluxpower HE:
Isolate the battery via DC circuit breakers before connecting it to the UPS
Connect the ground cable to the relevant bar before carrying out any other
connection inside the device
INJURY HAZARD DUE TO ELECTRIC SHOCK!
If primary power isolators are installed in an area other than the UPS one,
you must stick the following warning label on the UPS. "ISOLATE THE
UNINTERRUPTIBLE POWER SUPPLY (UPS) BEFORE WORKING ON
THIS CIRCUIT"

2.3.6 OPERATION

The installation to which the UPS systems belong must comply with all the
current safety standards (technical equipment and accident-prevention
regulations). The device can be started, operated and disconnected only
by authorized personnel.
The settings can only be changed using the original interface software.
INJURY HAZARD DUE TO ELECTRIC SHOCK!
During operation, Fluxpower HE converts power characterized by high
voltages and currents.
All the doors and the covers must remain closed.
INJURY HAZARD DUE TO CONTACT WITH TOXIC SUBSTANCES
The battery supplied with the UPS contains small amounts of toxic materials.
To avoid accidents, the directives listed below must be observed:
Never operate the UPS if the ambient temperature and relative humidity
are higher than the levels specified in the technical documentation.
Never burn the battery (risk of explosion).
Do not attempt to open the battery (the electrolyte is dangerous for the eyes
and skin).
Comply with all applicable regulations for the disposal of the battery.
13

Advertisement

loading