Options And Functions - Whirlpool WFCR 86430 Health & Safety, Use And Care And Installation Manual

OPTIONS AND FUNCTIONS

OPTIONS selectable directly by pressing the
relative button
! If the selected option is not compatible with
the programme set, an error warning tone
times. The option is not selected.
FRESHCARE+
If associated with wash cycles, this option
increases their performances by generating
steam to block proliferation of the main
sources of unpleasant odours inside the
appliance (exclusively for the wash). After
the steam phase, the machine runs a
delicate cycle with slow drum rotations.
When the FRESHCARE+ option is associated
with drying cycles, it prevents stubborn
creases from stabilising on garments,
thanks to slow drum rotations.
The FRESHCARE+ cycle starts at the end of
the wash or drying cycle and continues for
maximum 6 hours; it can be interrupted at
any time by pressing any button on the
control panel, or by turning the knob. Wait
roughly 5 minutes before opening the door.
START DELAY
h.
To set the selected programme to start
at a later time, press the button to set the
desired delay time. The
the display when this function is enabled.
To cancel the delayed start, press the button
again until the value "0" is shown on the
display.
LOCK BUTTON
to lock the control panel, press and hold the
button "Dry only" for approximately 3 seconds.
the symbol lights on the display to indicate
that the control panel is locked (with the
exception of the
unintentional changes to programmes,
especially with children near the machine.
If any attempt is made to use the control
panel, the symbol
To unlock the control panel, press and hold
the button "Dry only" for approximately 3
seconds.
symbol lights on
h.
button). This prevents
EN
.
15
15