Radio Led; Status Led; Protection Led - Ceragon FibeAir IP-20 Series User Manual

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
• Orange - Admin is Enabled and a cable is connected to the interface.
• Blinking Orange - Admin is Enabled and a cable is connected to the interface,
and there is traffic on the interface.
23.8.4

Radio LED

The Radio LED indicates the status of the radio link:
• Off – The radio is off; the carrier is Admin = Disabled in the Interface Manager.
Green - The power is on, and the carrier is operational (up).
•
• Orange – A signal degrade condition exists on the carrier.
• Red - A loss of frame (LOF) or excessive BER condition exists on the carrier.
23.8.5

Status LED

The Status LED indicates the status of the main board:
• Off – The power is off.
Green - The power is on, and no alarms are raised on the motherboard.
•
• Orange – The power is on, and one or more minor alarms or warnings are
raised on the motherboard.
• Red - The power is on, and one or more major or critical alarms are raised on
the motherboard.
23.8.6

Protection LED

The Protection LED operates in a protected configuration to indicate the
protection status:
• Red – A protection alarm exists (cable disconnected, mismatch configuration,
or mate communication not working). Note that only the active unit will have
a red LED.
• Orange -Protection is enabled, and the unit is in standby mode.
Green - Protection is enabled, the unit is in active mode, and no protection
•
alarms are present.
• Off – Protection is not enabled.
Page 746 of 825
Ceragon Proprietary and Confidential