Table of Contents
Advertisement
Telephone troubleshooting
Problem
The line is bad and the
symbol is displayed.
The handset emits an alert
beep when you try to make
an outside call.
The handset emits an alert
beep when you try to make
an internal call.
Memo recorder troubleshooting (Onis Memo only)
Problem
The memo recorder does not
record your outgoing message.
The memo recorder does not
record the incoming calls.
The memo recorder stopped
automatically.
The red indicator light on the
base station flashes quickly.
NO OUT MES
"
" is displayed.
The remote control does not
work.
If further troubleshooting is necessary, please contact your PHILIPS Help
Desk.
Cause
A
The handset has reached its radio range
limit.
An outside call is in progress on another
handset.
A
The
symbol is displayed. The handset
is out of range of the base station.
A
The
symbol is displayed. The handset
is not registered with the base station.
Another handset is using menu mode
and the base station is busy.
The handset you are trying to reach may
be busy in an another call or out of range.
You are not close enough to the
handset microphone.
The memory is full.
You have not switch on the memo
recorder.
The message record switch is set to
off.
The memo recorder memory is full.
The memo recorder's maximum
recording capacity (approx. 6 mn)
has been reached.
A power failure has occurred.
You have not recorded an outgoing
message.
You have not entered the right code. Try again or see "Calling into your
You have not set a remote control
code.
Useful tips and maintenance
Cause
Solution
Move closer to the base station
and try again.
Wait for the call to end and try
again.
Move closer to the base station
and try again.
Register the handset with the
base station and try again.
Wait for the other handset to
leave menu mode and try again.
Wait for the other handset to
become available and try again.
Solution
Record a new outgoing message
closer to the microphone.
Erase messages to free sufficient
memory capacity.
See "Switching on the memo
recorder" on page 14.
See "Switching message record
on or off" on page 17.
Erase messages to free sufficient
memory capacity.
Erase messages to free sufficient
memory capacity.
Reset the day and time setting of
the handset (see "Setting the day
and time" on page 13).
See "Recording an outgoing
message" on page 12.
memo recorder by remote control"
on page 18.
See "Entering a remote control
code" on page 16.
29
Advertisement
Table of Contents
