Table of Contents
Advertisement
484 Wheels and tires
Aluminum hub cap
To remove: position socket
2
#
1.
%
The socket can be found in the tire-change
tool kit.
Position wheel wrench
3
on socket 2.
#
Using wheel wrench 3, turn hub cap
#
counter-clockwise and remove it.
To install: position hub cap
1
#
it is completely flush with the wheel.
Position socket
2
on hub cap 1.
#
Attach wheel wrench
#
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
page 483).
/
on hub cap
Important notes on using the jack:
Use only a vehicle-specific jack that has
R
been approved by Mercedes-Benz to raise
the vehicle.
The jack is only designed for raising and
R
holding the vehicle for a short time while a
1
wheel is being changed and not for mainte‐
nance work under the vehicle.
and turn until
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large,
flat, load-bearing, non-slip underlay.
3
to socket
2
and
The foot of the jack must be positioned verti‐
R
cally under the jack support point.
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the
R
vehicle.
Never lie under the vehicle.
R
Do not start the engine and do not release
R
the electric parking brake.
Do not open or close any doors or the tail‐
R
gate.
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
