Table of Contents
Advertisement
6.2.1 - COIL ASSEMBLY ANCHOR SYSTEM
The coil assemblies are fixed in position by suspension springs designed to press them against the lower
surface of the glass top.
To remove the coil assembly, simply lift it out, removing the springs from their respective positioning holes
(see Fig. 40).
Fig. 40
1. INDUCTION COIL ASSEMBLY
2. COIL ASSEMBLY RETAINING
SPRING
3. SPRING POSITIONING HOLE
6.2.2 - POWER SUPPLY CONNECTION TO INDUCTION COILS
Fig. 41
1 - POWER BOARD MODULE
2 - POWER CABLE (BLACK) TO
REAR INDUCTION COIL
3 - POWER CABLE (RED) TO REAR
INDUCTION COIL
4 - POWER CABLE (BLACK) TO
FRONT INDUCTION COIL
5 - POWER CABLE (RED) TO FRONT
INDUCTION COIL
6 - CONTROL BOARD
6.2.3 - REMOVING THE SUSPENSION SPRINGS
To remove the suspension springs from the coil assemblies, slide the spring clip and remove from the lower
side of the coil assembly (see Fig. 42).
Fig. 42
1 - POWER BOARD MODULE
2 - POWER CABLE (BLACK) TO
REAR INDUCTION COIL
3 - POWER CABLE (RED) TO REAR
INDUCTION COIL
4 - POWER CABLE (BLACK) TO
FRONT INDUCTION COIL
5 - POWER CABLE (RED) TO FRONT
INDUCTION COIL
6 - CONTROL BOARD
SOI 05.09 FV
31/36
599 71 58-20
Advertisement
Table of Contents
