IBM 3274 Planning, Setup, And Customizing Manual page 35

2-2
4. Enter the following information on the Initial Customizing Procedure Form in
Chapter 4:
a. The type of keyboard (typewriter or data entry) to be used by the operator.
Note: If using a 76- or 88-key Japanese English or Japanese Katakana keyboard,
specify the number of keys and keyboard type.
b. In step 1, the identification of each diskette to be used.
c. In step 7, enter the response to sequence number 031. This is the number (0-3) of
RPQ diskettes to be used.
d. In step 8, use as a guide the information in Chapter 3 that applies to the model to
be customized and enter the responses to be keyed in by the operator. Use that
portion of the step that applies to your configuration.
5. If the printer authorization matrix is to be defined, or if changes are to be made to
the existing matrix, fill out the Printer Authorization Matrix Form at the end of
Chapter 4.
6. The following should be given to the operator who will customize the 3274:
a. Copy of the Color Convergence Procedure (Appendix E) (if required)
b. Completed Initial Customizing Procedure Form
c. Completed Printer Authorization Matrix Form (if required)
d. Copy of the "Operator Codes" chart (Figure 44)
e. Copies of the "8421 Indicator Codes" charts (Figures 4-5, 4-6, and 4-7)
f.
Copy of the appropriate keyboard layout showing valid keys (Figures 4-1 and 4-2)
g. Feature and system diskettes, and language diskette (if applicable)
h. RPQ diskette(s) (if applicable)
i. Copy of the Subsystem Verification Procedure (Appendix D)
It may be convenient for the planner at the central or host system location to prepare the
Initial Customizing Procedure Form for several 3274s at other locations and to forward
the forms to each location.