Coffee Preparation; Pre-Infusion - Gaggia 10001451 Operating Instructions Manual

ction. The symbols placed under the buttons
will re-start lighting up alternatively.
The appliance is now ready to dispense
excellent coffees.
N.B.: to brew 1 coffee press button (2 or 3)
once; to brew 2 coffees press button (2 or
3) twice.

Pre-Infusion

The machine allows you to adjust the dosage
settings so that the water produced for the COF-
FEE dose is preceded by a pre-infusion step.
Press the dose button (2) and the normal coffee
cycle is preceded by a brief, timed jet of water
that moistens the coffee wafer before the actual
coffee making cycle starts.
This function allows you to get the most flavor
out of the coffee wafer.
PRE-INFUSION is not available on the dose
button (3).
N.B.: the machine comes from the factory with
PRE-INFUSION function set to ON. Should
you choose to deactivate this function you
will need to enter the programming mode
(see
"Coffee dose
and press the steam button (5). The indicator
light on the button will turn off.
The indicator light on the steam button (5)
is ON when the PRE-INFUSION function is
ON. Vice versa, if the indicator light is OFF,
then the PRE-INFUSION function is OFF.

Coffee preparation

1 Follow the procedure described under "Pre-
paration".
2 Select the correct filter basket (10 or 11) and
insert it in the filter holder (9).
Use the small filter for 1 cup and the large
filter for 2 cups of espresso.
Then insert filter-holder (9) into the appliance
and wait at least 10 minutes.
3 After the warm-up period, remove the warm
programming")
• 11 •
filter-holder (9) from the brewing head and
fill with correctly ground espresso coffee
using the measuring spoon provided.
Place one level measure of coffee in basket
for each cup of espresso. Do not overfill.
Gently tamp down coffee with the tamper
(18) provided. Do not compress too firmly.
4 Clean any excess coffee from the rim of
filter holder (9). Insert filter holder into brew
head by holding handle approximately 45
degrees to the left as you face machine.
When properly aligned,move handle firmly
to the right to lock into position.
The handle should point to the front of the
machine or slightly to the right.
5 Place one or two espresso cups on the drip plate
to line up with the spouts of the filter holder. Press
the button corresponding to the stored coffee
dose. Espresso will start to flow into cups.
6 The coffee dispensing will automatically
stop when the preset level is reached (see
Coffee dose programming);however
it is possible to stop the coffee dispensing
by pressing the button (2 or 3) as previously
selected.
When properly made, the espresso will have
a light brown foam "crema" floating on the
top. If not, refer to "In the event of
faulty function".
7 Remove cups and serve.
8 To make more espresso, carefully and slowly
remove the filter holder by moving handle
to the left. Be careful as hot water will be on
top of the coffee grinds in the holder. Some
water will continue to drip from brewing
head as filter holder is removed. That is
normal and due to the pump pressure in the
system.
Knock out used coffee grinds from filter. For
more espresso repeat steps 2 to 7 above.
9 To prepare coffee manually, carry out steps 2
through 5 and then press button 6. When you
have obtained the desired quantity of coffee
in the cup, press button 6 again to stop the
cycle. Then proceed with steps 6 and 7.
N.B.: Dispensing should not exceed 40
seconds.
ENGLISH