Table of Contents
Advertisement
42/61
Bosch Rexroth AG
Assembly
6.3
Encoder Connection
The encoder connection is designed as a flange socket on the motor housing
or as a cable with a coupling. The cables for connecting the motor encoder
and the controller must have a compatible plug on the motor side.
The flange sockets on the motor side have different designs and codings.
The corresponding plugs and cables can therefore not be interchanged. For
connection assignment of single flange sockets refer to the project planning
manual
Rexroth 2AD.
Connector and coupling are connected with each other and screwed by
hand. Observe the mechanical coding.
Fig.6-13:
Encoder connection - pole picture and coding
DOK-MOTOR*-2AD********-IT01-EN-P
Rexroth 2AD Asynchronous Housing Motors
Advertisement
Table of Contents
