This Is How You Remove An Tm54F - Siemens SINUMERIK 828D Series Software And Hardware Service Manual

4.18.3

This is how you remove an TM54F

Overview
The activities that must be taken into account when replacing an TM54F are described below.
If a TM54F has a hardware defect, then it must be replaced by an identical module.
Preconditions:
● The module is defective and must be replaced.
● The control cabinet is in a no-voltage condition, all of the connectors and cables are labeled.
Removing
Figure 4-63
Procedure:
1. Label connectors X514 and X524 for the sensor and electronics power supply prior to
withdrawing them.
2. Withdraw the connected DRIVE-CLiQ cables X500 and X501 and write the slot designation
on the cable.
3. Label the connected connectors X520 - X535 for digital inputs and outputs prior to
withdrawing them.
4. Release the protective conductor connection and write the position designation on the
cable.
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1
TM54F removal
Service cases - hardware
4.18 Terminal Modules
223