Using The Machine For The First Time Or After A Long Period Of Inactivity; Rinse/Self-Cleaning Cycle - Gaggia RI9833/70 Operating Instructions Manual

Using the machine for the
first time or after a long
period of inactivity.
These simple operations will make it pos-
sible to always brew excellent coff ee.
1 Place a large container under the
dispensing spout.
2 Before starting the procedure, check
that the following icons are displayed.
Steady on
3 Select the pre-ground coff ee function
by pressing the "
more times.
Do not add the pre-ground
coff ee to the compartment.
The icon will appear on the display.
Steady on
4 Press the button to brew a long cof-
fee.
5 Wait until brewing is completed and
empty the water tank.
6 Repeat the operations from step 1 to
step 5 for 3 times; then continue with
step 7.
7 Place a container under the steam wand
(Pannarello, if supplied).
8 Turn the selector switch clockwise to set
it to the "
" button one or
" position.
The following icon will be displayed.
Steady on
9 Dispense water until the no water si-
gnal is displayed, then turn the selec-
tor switch counter-clockwise to set it
to the " " position.
Steady on
10 At the end, fill the water tank again.
Then the products can be brewed as
described in the following sections.

Rinse/Self-cleaning Cycle

This cycle allow rinsing the coff ee circuits
with fresh water.
The cycle is carried out:
• At machine start (with cold boiler)
• After priming the water circuit (with
cold boiler)
• During the Stand-by preparation phase
(if a coff ee product has been brewed)
• During the phase of activating the
stand-by mode after pressing the
"STAND-BY" button (if a coff ee product
has been brewed).
A small amount of water will be dispen-
sed to rinse and heat all the machine
components; during this phase the icons
blink in sequence.
Cyclic blinking
Wait for the cycle to fi nish automatically.
You can stop dispensing by pressing
either coffee button and/or the
"Stand-by" button.
• 29 •