Advertisement
High Speed Transducer
Important: For Transom Mount transducer installations, install
the third mounting screw after the final transducer adjustments.
Hand tighten only (see Figure 11).
Your depthsounder is now ready for operation.
Note: If your depthsounder is temperature-capable, your
transducer includes a temperature probe. When your
transducer is hooked up, the temperature probe will allow
your depthsounder to display water temperature
automatically.
This accessory works with a number of Humminbird depthsounder
products. Some products may require disassembly of the depthsounder
mounting bracket in order to connect the cable. Refer to the operation manual
for your depthsounder.
C
R
USTOMER
ESOURCE
Your Humminbird accessory is designed for trouble-free
operation and is backed by the same warranty as our
depthsounders, VHF marine-band radios, and GPS
navigation equipment. Refer to your Humminbird Warranty
WARNING: Avoid contact or close proximity with the transducer during
operation of your fishfinder. Touching any transducer during operation can
cause discomfort and may lead to personal injury. Handle the transducer
only when the power of the fishfinder is off.
C
ENTER
Throughout the U.S. and Canada, hours are: Monday-Friday,
8:00 a.m. to 4:30 p.m. Central time
Eufaula, AL 36027
M
AINTENANCE
the effectiveness of the transducer. Periodically clean the face of the
transducer with a biodegradable detergent or hot water.
WARNING! Do not touch an active transducer during
operation, as this may cause physical discomfort and may
result in personal injury in the form of tissue damage.
Handle the transducer only when the power to the
depthsounder is off.
Pivoting the transducer up in the bracket may allow better access for
inspection or cleaning. During cleaning, your boat should not be running, and
this procedure is normally performed while the boat is out of the water.
In some cases it may take some time to wet the transducer when returned
to the water. Small air bubbles can cling to the surface of the transducer and
interfere with proper operation. These bubbles will dissipate with time, or you
may wipe the face of the transducer with your fingers after the transducer is in
the water.
Card for the specific details of this warranty. If you have any
questions, visit our web site at www.humminbird.com,
select the Product Support tab/link or call our Humminbird
Customer Resource Center:
334-687-0503
Humminbird
108 Maple Lane
If your boat remains in the water for long periods of
time, algae and other marine growth can reduce
WARNING: Disassembly and repair of this electronic unit should
only be performed by authorized service personnel. Any modification
of the serial number or attempt to repair the original equipment or
accessories by unauthorized individuals will void the warranty.
Handling and/or opening this unit may result in exposure to lead, in
the form of solder.
WARNING: This product contains lead, a chemical known
to the State of California to cause cancer and birth defects
and other reproductive harm.
4
Advertisement
