Since continuous transmission is prohibited, you only hear your baby when it makes sounds.
,
The antennas on both units are fixed. Do not pull at them or try to remove them.
,
Preparing for use
You can use the baby monitor from the mains or on batteries.
Mains operation
1
Put the small plug in the baby unit and put the adapter in a wall socket. (Fig. )
Put the small plug in the parent unit and put the adapter in a wall socket. (Fig. )
Battery operation
Even if you do not intend to use the baby monitor on batteries, we advise you to insert batteries
into both units. This guarantees automatic back-up in case of mains failure.
Both the parent unit and the baby unit run on four 1.5-volt R6 AA batteries. We strongly advise you
to use Philips LR6 PowerLife batteries.
Replace the batteries when the power-on light blinks red when you operate the baby monitor on
batteries.
Make sure your hands and the units are dry when you insert the batteries.
Note:Do not mix old and new batteries or different types of batteries.
Note:Remove the batteries if you are not going to use the baby monitor for a month or more.
Note:If the batteries are left in the unit when it is operated on mains power, check them for leakage
every six months.
Baby unit
1
Unlock the battery compartment lid by turning the locking knob with a coin. Then remove
the lid. (Fig. )
Insert four 1.5-volt AA batteries. (Fig. 5)
Make sure the + and - poles of the batteries point in the right direction.
Close the battery compartment lid by turning the locking knob with a coin.
Parent unit
1
Turn the locking knob in the bottom a quarter turn (1) and slide the battery compartment
lid downwards to remove it (). (Fig. 6)
Insert four 1.5-volt AA batteries. (Fig. 7)
Make sure the + and - poles of the batteries point in the right direction.
Slide the battery compartment lid back onto the battery compartment (1) and turn the
locking knob in the bottom a quarter turn to fasten the lid (). (Fig. 8)
using the appliance
1
Place the two units in the same room to test the connection. (Fig. 9)
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
Press the on/off button to switch on the baby unit. (Fig. 10)
The power-on light starts to burn green.
,
Turn the volume control to switch on the parent unit and to set the volume to the level you
prefer. (Fig. 11)
The power-on light starts to burn green.
,
EngliSh
7