Work Process For Wall Sawing; Start Blade Rotation; After Work Is Completed - Husqvarna RC 455 Operator's Manual

Operator's Manual RC 455

Work process for wall sawing

Start blade rotation

1. Start the motor on the hydraulic unit by pressing the
remote control's green button once.
When the motor starts, the diesel-driven generating set
goes from idling to working speed and starts to
produce a flow.
Press the green button on the remote control once
more to stop the motor.
1. Turn the control for blade rotation to its maximum
position to start blade rotation and the water coolant.
2. Start the blade motion by turning the blade motion
knob on the remote control.
Work process for wall sawing
3. Start the horizontal motion by turning the horizontal
motion knob in the desired direction.

After work is completed

1. After the work is completed, shut down the blade
rotation by turning the knob on the remote control back
to "0"
2. Run down the engine to idling by pressing the remote
control's green button.
CAUTION
Always clean all the equipment at the end of
the working day
English - 13