Advertisement
Figure 2
Mounting the XLS/Desigo Fire Safety Modular/Cerberus PRO Modular Modules in the MSE-3 Backbox
Install the Inner Door
Siemens Industry, Inc.
Building Technologies Division
MSE-3
BACKBOX
Install the inner door by following the steps listed below.
1.
Place two of the four #6-32x5/16 screws provided in the top and bottom
holes on the right-hand side of the backbox.
2.
Tighten the screws just a few turns leaving a 1/8-inch gap between the
head of the screws and the backbox.
3.
Slide the inner door into position under the screws.
4.
Make certain the flange at the left-hand top of the inner door is seated in
the lip in the backbox. (Refer to Figure 3.) Adjust the door as needed so that
it seats securely in the enclosure.
MSE-3
BACKBOX
LIP OF
DOOR
FLANGE
INNER
DOOR
Figure 3
Installing the Inner Door
CC-5
PSC-12
PTB
BATTERIES
3
8-32x5/16
SCREWS
(QTY. 4)
LOCATION
OF OPTIONAL
HTSW-1 TAMPER
SWITCH
A6V10328636_en--_c
Advertisement
