LG CS56 Series Owner's Manual page 13

Hide thumbs Also See for CS56 Series:
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
1
Antenna Isolator Installation Guide
y Use this to install TV in a place where there is a voltage difference between GND of power and GND of antenna signal.
y
- If there is a voltage difference between GND of power and GND of antenna signal, the antenna contact might be
heated and excessive heat might cause an accident.
y You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. Avoid
y
disconnecting the antenna Isolator after installation.
y Exterior of antenna isolator:
y
y Connection method :
y
- Connect Plug 1 with a signal cable.
- Connect Plug 2 with ANT input end on the back of TV.
"Equipment connected to the protective earthing of the building installation through the mains connection or through other
equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some
circumstances create a fire hazard.
Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below
a certain frequency range (galvanic isolator, see EN 60728-11)"
When applying the RF Isolator, a slight loss of signal sensitivity can occur.
Parts and buttons
NOTE
The TV
can be placed in standby mode in order to reduce the power consumption.
y
y
should be turned off if it will not be watched for some time, as this will reduce energy consumption.
y The energy consumed during use can be significantly reduced if the level of brightness of the
y
picture is reduced, and this will reduce the overall running cost.
CAUTION
y Do not step on the glass stand or subject it to any impact. It may break, causing possible injury
y
from fragments of glass, or the TV may fall.
y Do not drag the TV. The floor or the product may be damaged.
y
Some models have a thin film attached on to the screen and this must not be removed.
y
y
Plug2
Plug1
or
Plug2
Plug1
Isolator
RF Coaxial Wire
RF Coaxial Wire
ASSEMBLING AND PREPARING
ANTENNA
IN
or
Isolator
ANTENNA
IN
or
STB
ANTENNA
Isolator
IN
ANTENNA
IN
And the
TV
5
ANTENNA
IN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents