Philips HQS964/10 Instructions For Use

3 Remove the detachable shaving head by pulling it
ENGLISH
from the device (fig. 8).
4 If a lot of hair has accumulated in the shaving head,
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
blow and/or shake the hairs out of the shaving
A
head and, if necessary, use the brush supplied to
B
clean it carefully.
C
D
E
F
5 Clean the inside of the appliance, especially the
G cutter, with the brush supplied.
H
I IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
J
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
For optimal safety, read these instructions carefully
and look at the illustrations before you start using
the appliance.
Make sure the appliance, cord and powerplug do
not get wet.
Only use the cord supplied with the appliance.
This appliance is only designed for contouring and
shaving facial hair. Do not use the appliance for any IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
other purpose.
Keep the appliance out of the reach of children.
Use, charge and store the appliance at a
temperature between 15°C and 35°C.
Check if the voltage indicated on the powerplug
(see type plate) corresponds to the local mains
voltage before you connect the appliance.
Do not use the appliance when the shaving head is
damaged or broken, as this may cause injury.
Noise level L= 66 dB(A) re 1pW
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
Removing the battery
1 Make sure the appliance is switched off while
charging. 1 Disconnect the appliance from the mains and let
the appliance run until the motor stops.
2 Insert the appliance plug into the appliance (fig. 1).
2 Remove the detachable shaving head by pulling it
3 Insert the powerplug into the wall socket.
from the device (fig. 10)
3 Remove the metal clip by means of a screwdriver
(fig. 11).
4 Remove the cover (fig. 12).
5 Pull out the printed circuit board (fig. 13).
6 Insert the screwdriver in the middle between the
printed circuit board and the battery.Turn the
screwdriver until the printed circuit board breaks
in two (fig. 14).
7 Separate the two broken circuit board parts from
the rechargeable battery by bending or turning
them several times until the connections break
(fig. 15).
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
After the appliance has been charged for the first 8 Take out the rechargeable battery.
time, use it until the battery is completely empty.
9 Dispose of the battery and the other components
Do not charge the appliance for more than 24
in an environmentally safe way.
hours.
Do not keep the powerplug plugged into the wall 10 Do not connect the appliance to the mains again
socket all the time. after it has been opened!
Do not recharge the appliance between contouring
sessions.
Discharge the battery completely twice a year by
If you need information or if you have a problem,
letting the motor run until it stops.Then recharge
please visit the Philips Web site at www.philips.com
the battery for at least 10 hours.
or contact the Philips Customer Care Centre in your
If the appliance has not been used for a long period
country (you will find its phone number in the
of time, it must be recharged for at least 10 hours.
worldwide guarantee leaflet). If there is no Customer
Care Centre in your country, turn to your local Philips
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
dealer or contact the Service Department of Philips
Domestic Appliances and Personal Care BV.
Guarantee restrictions
The shaving foil is not covered by the terms of the
international guarantee.
Preparing your beard for contouring
POLSKI
1 Use a beard trimmer to trim your beard (fig. 3).
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
2 Use a shaver to shave larger areas of the skin
A
(fig. 4).
B
Start contouring
C
D
E
F
G
H
I
1 First, slide the pop-up precision trimmer out until
J
you hear a click and feel the trimmer snap into
position.You will now see the slide-out mark (fig. 5).
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
2 Shape the contours of your beard and sideburns
with the pop-up precision trimmer.
3 Finally, shave the small areas that need to become
smooth with the shaving head of the contouring
appliance (fig. 7).
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
Do not use abrasives, scourers or liquids such as alcohol,
petrol or acetone to clean the appliance.
Do not immerse the appliance in water.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
1 Switch the appliance off and disconnect it from the
mains before you start cleaning it.
2 Make sure that the pop-up precision trimmer has 1
been properly slid into the appliance.
2
3
1
2
3
4
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
5
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
6
7
8
9
10
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
1
A
2
B
C
D
E
F
G
H
I
1
J
2
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
3
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
1
1
2
2 3
3
4
5
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
1
2
1
2
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
3
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
1
2
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
3
4
5
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
1
IIIIIIIIIIIIIIIIIIIIIIIIIII
2
3
4
5
6
7
8
1 2 3
4 5 6
7 8 9
10 11 12
13 14 15
9
10
A
B
1
C
D
2
E
F
G
H
I
J
1
2
3
1
2
3
1
2
3
4
PRECISION SHAPER
TONDEUSE DE PRÉCISION À CONTOURS
Instructions for use
Mode d'emploi
964
RECHARGEABLE
u
4203 000 52711
5
1
2
3
4
5
6
7
8
9
10