Replacing Older Modules - Siemens CP 443-1 Manual

Notice
The configuration of fault−tolerant connections when using this CP is prevented
only as of STEP 7 version V5.3 service pack 1. If you are still using STEP 7
version V5.3, please avoid configuring fault−tolerant connections in conjunction
with this CP.
9.3

Replacing Older Modules

The CP 443−1 Advanced described here allows communication both using the ISO
transport protocol as well as the TCP/IP protocol. It also includes the full IT
functionality of the CP 443−1 IT. It is fully compatible with and, taking into account
the restrictions described above (adapted configuration data), can be used to
replace the following previous modules:
S CP 443−1 ISO with order number 6GK7 443−1BX00−0XE0
S CP 443−1 ISO with order number 6GK7 443−1BX01−0XE0
S CP 443−1 TCP with order number 6GK7 443−1EX00−0XE0
S CP 443-1 TCP with order number 6GK7 443-1EX01-0XE0.
S CP 443-1 with order number 6GK7 443-1EX02-0XE0.
S CP 443-1 with order number 6GK7 443-1EX10-0XE0.
S CP 443−1 with order number 6GK7 443−1EX11−0XE0
S CP 443−1 IT with order number 6GK7 443−1GX00−0XE0
S CP 443−1 IT with order number 6GK7 443−1GX10−0XE0
S CP 443−1 IT with order number 6GK7 443−1GX11−0XE0
Module Replacement
When replacing an older module with the module described here, please keep to
the steps outlined below:
CP 443-1 Advanced for Industrial Ethernet / Manual Part B4A
Release 01/2007
C79000-G8976-C193-06
9 Compatibility with Predecessor Products
B4A−57