STANDBY FIRMWARE: To download the TV startup
•
data from the USB device. Only used in software
download.
•
IBOARD NVM: To download the TV settings from the
USB device.
•
IBOARD FIRMWARE: To update iboard software from
the USB device. Only used in software download.
•
ALL: To download all the software upgrades from the
USB device.
•
START: To start the software download.
» The TV will restart automatically upon the completion of software
download. There will be multiple downloads and restart cycles
when download ALL is selected.
Note
•
"Firmwares" cannot be copied from the TV to USB. (only NVMs may be
copied from the TV.)
•
The STANDBY FIRMWARE is rarely updated and is not included when
SW TYPE > ALL is selected. To update the STANDBY FIRMWARE, the
SW TYPE > STANDBY FIRMWARE must be uniquely selected.
Configure the V-chip and closed caption settings
1
Enter the Philips Hospitality setup menu.
2
to select CONFIGURATION > CC/ V-CHIP.
Press
CC / V-CHIP
SAVE CC
CC
DIGITAL CC MODE
ANALOG CC MODE
V-CHIP MENU ITEM
SAVED V-CHIP
V-CHIP SETUP
3
Press
to select one of the following options:
•
SAVE CC: Select YES to use the last used CC mode. Select NO
to use the CC mode defined in the next option.
•
CC: Select a CC mode that is used when the TV is turned on.
If you select CONFIGURATION > CC/ V-CHIP > CC > ON,
the following options appear:
•
DIGITAL CC MODE: Allows you to select your digital CC
options. Select an option from CS1 to CS6. If this option is not
available for the current digital channel, the TV will switch to
ANALOG CC MODE.
•
ANALOG CC MODE: Allows you to set your analog CC
options. Select an option from CC1 to CC4 and TXT1 to
TXT4.
•
V-CHIP MENU ITEM: Select YES to allow the guest to change
the V-CHIP settings. Otherwise, select NO.
•
SAVED V-CHIP: Select YES to save all the V-chip settings.
Otherwise, select NO.
•
V-CHIP SETUP: Select one of the available options to change
the V-CHIP settings:
•
CLEAR ALL RATINGS: To clear all the ratings.
•
US MOVIE RATING: To enable or disable the movie ratings.
•
US TV RATING: To enable or disable the TV ratings.
•
D. RATING: To configure the downloadable (RRT-5) rating.
14 Clone data (TV Setup Data)
1
Enter the Philips Hospitality setup menu.
2
Press
3
Press to select one of the following options:
•
•
Download clone data from a USB device
YES
ON
1
CS1
Enter the Philips Hospitality setup menu.
2
CC1
Press
3
NO
Press to select USB.
NO
>
4
Press
•
•
Download clone data from an RF channel
1
Enter the Philips Hospitality setup menu.
2
Press
3
Press to select RF.
to select SMARTCLONE > SOURCE.
USB: To download clone data (TV setup data) from a USB
device to a TV or a TV to a USB device.
RF: To download clone data (TV setup data) from an RF
channel to a TV.
SMARTCLONE
SOURCE
CABLE TUNING
RF CHANNEL NUMBER
RF TO TV
to select smartclone SOURCE.
SW DOWNLOAD
SOURCE
DIRECTION
SW TYPE
START
to select one of the following options:
USB TO TV: To download clone data (TV setup data) from a
USB device to TV.
TV TO USB: To upload clone data (TV setup data) from a TV
to a USB device.
to select smartclone SOURCE.
RF
YES
87
>
USB
TV TO USB
IBOARD NVM
>
EN
19