Connecting Digital Audio Components Via Digital Cables - Silvercrest KH 6519 Operating Instructions Manual

Hide thumbs Also See for KH 6519:
Table of Contents

Advertisement

Available languages

Available languages

Connecting a HiFi system:
L/R
• Connect the audio output sockets
on the rear panel of the DVD player to
the corresponding audio inputs on the HiFi system with an audio cinch ca-
ble.
Make sure that the red and white colour markings correspond.
• Check with the instruction manual which settings on the HiFi system may
be necessary in order to reproduce sound via the HiFi system during the
playback of a DVD, VCD/S-VCD, Audio or MP3 CD from the DVD player.
Note:
For an optimal sound experience place your HiFi system's loud speakers to
the left and to the right of the television, on which you connected the DVD
player.
If you connected the DVD player to the television via a Scart cable the Audio
signal will be transmitted via the cinch cable to your HiFi system as well as via
the Scart cable to the television. In this case, set the volume of the television
to the lowest value.

9.2 Connecting digital audio components via digital cables

In order to enjoy sound playback throughout the room from correspondingly
equipped DVDs (recognizable by the Dolby Digital or DTS logos), you can
connect the DVD player to a digital audio component, for example, a Dolby
Digital or DTS receiver or a suitable surround sound system.
you can purchase the necessary cables for the hereafter described connection
variants from your dealer.
Firstly check with the digital components instruction manual to see if it allows
for connection to the DVD player...
• via a coaxial cable
• or via an optical cable.
Connection via coaxial cable
To connect the DVD player to a digital audio component with a digital coaxial
cable:
COAXIAL
• Connect the
inscribed socket to the corresponding socket on the di-
gital audio component.
Connecting via optical cable
To connect the DVD player to a digital audio component with an optical cable:
COAXIAL
• Remove the protective plug from the
inscribed socket on the rear
panel of the DVD player and insert the optical cable plug.
• Insert the plug at the other end of the optical cable in the corresponding
socket of the digital audio component.
Note:
The optical cable is a glass fibre cable and must not be bent during installa-
tion. Otherwise the glass fibre contained in the cable could break and the ca-
ble would become unusable.
Note:
Make sure that no dirt can enter into the optical cable socket. This could cause
signal interference. Always insert the protective plug into the socket if no opti-
cal cable is connected.
Page 63

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kh 6520

Table of Contents